help sizing designing realization jib crane for parallel lathe
|
help sizing designing realization jib crane for parallel lathe
|
03-03-2018, 05:21 PM
What you are attempting to do is going to require some fairly complex engineering calculations to ensure that it is safe to use. Just looking at your pics, it appears that the pivot is already under designed to bear the force the beam will put on it. Better get some qualified help at your end before continuing.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
help sizing designing realization jib crane for parallel lathe - by scecchigno - 03-03-2018, 12:56 PM
RE: help sizing designing realization jib crane for parallel lathe - by TomG - 03-03-2018, 05:21 PM
RE: help sizing designing realization jib crane for parallel lathe - by f350ca - 03-03-2018, 05:46 PM
|
