|
mill vise
|
02-19-2018, 10:24 PM
(02-19-2018, 06:01 PM)SteveG Wrote: There's a few hits on ebay.com if you search for "2 piece machine vice". Cheers, Steve, that's the same as mine except for the cast-in logo. I don't recall paying that much for mine but I wouldn't think twice about replacing it for that price ! That vise and a horizontal mill are like pie and ice cream 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: mill vise - by Hawkeye - 02-18-2018, 11:17 AM
RE: mill vise - by SteveG - 02-18-2018, 07:41 PM
RE: mill vise - by f350ca - 02-18-2018, 08:53 PM
RE: mill vise - by pepi - 02-18-2018, 10:15 PM
RE: mill vise - by randyc - 02-18-2018, 11:57 PM
RE: mill vise - by the penguin - 02-19-2018, 11:18 AM
RE: mill vise - by the penguin - 02-19-2018, 11:27 AM
RE: mill vise - by randyc - 02-19-2018, 04:18 PM
RE: mill vise - by randyc - 02-19-2018, 05:39 PM
RE: mill vise - by SteveG - 02-19-2018, 06:01 PM
RE: mill vise - by randyc - 02-19-2018, 10:24 PM
RE: mill vise - by Vinny - 02-20-2018, 12:04 AM
RE: mill vise - by Dr Stan - 03-20-2018, 11:57 AM
RE: mill vise - by 2Young2 - 03-18-2018, 11:14 AM
RE: mill vise - by Vinny - 03-20-2018, 02:13 PM
RE: mill vise - by Dr Stan - 03-20-2018, 03:02 PM
RE: mill vise - by Vinny - 03-20-2018, 06:36 PM
RE: mill vise - by Dr Stan - 03-20-2018, 08:54 PM
RE: mill vise - by EdK - 03-21-2018, 03:51 PM
RE: mill vise - by Vinny - 03-20-2018, 10:50 PM
RE: mill vise - by Dr Stan - 03-21-2018, 02:10 PM
RE: mill vise - by Mike E. - 07-28-2018, 09:28 AM
RE: mill vise - by Vinny - 07-28-2018, 11:45 AM
RE: mill vise - by Highpower - 07-31-2018, 03:35 PM
RE: mill vise - by Highpower - 07-28-2018, 04:15 PM
RE: mill vise - by Mike E. - 07-29-2018, 05:48 AM
RE: mill vise - by Vinny - 07-31-2018, 06:35 PM
RE: mill vise - by big o - 08-05-2021, 06:08 PM
RE: mill vise - by Vinny - 08-05-2021, 09:35 PM
RE: mill vise - by Dr Stan - 08-07-2021, 01:36 PM
RE: mill vise - by Vinny - 08-09-2021, 09:16 PM
|
