|
Help Tight offset bend
|
02-06-2018, 06:57 PM
Hand / Hammer forging is not an option. This is for a series of production quality test market samples. The parts are highly visible and cosmetic. Repeatability is a primary factor.
I have posted the same query on other forums also. I think I have been presented a solution. Thank you Steve and Mike for your input. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tight offset bend - by Mike s. - 02-05-2018, 08:42 PM
RE: Tight offset bend - by SteveG - 02-05-2018, 10:36 PM
RE: Tight offset bend - by Hawkeye - 02-05-2018, 11:35 PM
RE: Tight offset bend - by Mike s. - 02-06-2018, 06:57 PM
RE: Tight offset bend - by Vinny - 02-06-2018, 09:04 PM
RE: Tight offset bend - by randyc - 02-08-2018, 10:03 PM
RE: Tight offset bend - by Dr Stan - 02-06-2018, 07:32 PM
RE: Tight offset bend - by Hawkeye - 02-06-2018, 11:31 PM
RE: Tight offset bend - by TomG - 02-09-2018, 07:19 AM
|
