Need some hold down advice
#19
There are also several low temp paraffin's available through various industrial suppliers such as McMaster Carr. These are a very hard paraffin designed specifically for the purpose of holding difficult to hold parts for machining. They work exceptionally well for parts where shape and size will not allow conventional clamping.
Reply
Thanks given by:


Messages In This Thread
Need some hold down advice - by Vinny - 02-02-2018, 01:27 PM
RE: Need some hold down advice - by dallen - 02-02-2018, 01:52 PM
RE: Need some hold down advice - by Vinny - 02-02-2018, 02:17 PM
RE: Need some hold down advice - by wawoodman - 02-02-2018, 02:55 PM
RE: Need some hold down advice - by Vinny - 02-02-2018, 03:02 PM
RE: Need some hold down advice - by Dr Stan - 02-02-2018, 03:43 PM
RE: Need some hold down advice - by TomG - 02-02-2018, 04:16 PM
RE: Need some hold down advice - by randyc - 02-02-2018, 04:38 PM
RE: Need some hold down advice - by Highpower - 02-02-2018, 05:31 PM
RE: Need some hold down advice - by f350ca - 02-02-2018, 05:47 PM
RE: Need some hold down advice - by randyc - 02-02-2018, 06:08 PM
RE: Need some hold down advice - by Vinny - 02-02-2018, 06:51 PM
RE: Need some hold down advice - by kwoodhands - 03-02-2018, 02:52 PM
RE: Need some hold down advice - by SteveG - 02-02-2018, 08:55 PM
RE: Need some hold down advice - by wawoodman - 02-03-2018, 06:41 PM
RE: Need some hold down advice - by Vinny - 02-03-2018, 07:55 PM
RE: Need some hold down advice - by TomG - 02-04-2018, 04:11 PM
RE: Need some hold down advice - by Vinny - 02-04-2018, 04:36 PM
RE: Need some hold down advice - by Highpower - 02-04-2018, 09:06 PM
RE: Need some hold down advice - by Mike s. - 02-05-2018, 08:14 PM
RE: Need some hold down advice - by Highpower - 02-05-2018, 08:29 PM
RE: Need some hold down advice - by Vinny - 02-06-2018, 12:10 AM
RE: Need some hold down advice - by EdK - 02-06-2018, 05:42 PM
RE: Need some hold down advice - by Vinny - 02-06-2018, 09:02 PM
RE: Need some hold down advice - by Vinny - 02-18-2018, 12:41 AM
RE: Need some hold down advice - by TomG - 02-18-2018, 09:08 AM
RE: Need some hold down advice - by Vinny - 02-18-2018, 11:01 AM
RE: Need some hold down advice - by Highpower - 02-18-2018, 03:11 PM
RE: Need some hold down advice - by Vinny - 02-19-2018, 12:19 AM
RE: Need some hold down advice - by Vinny - 03-02-2018, 09:04 PM



Users browsing this thread: 5 Guest(s)