Need some hold down advice

Thread Modes

Need some hold down advice

Vinny

Another Whipping Boy

Posts: 2,607
Threads: 99
Joined: Dec 2014
Location: Michigan

The following 3 users Like Vinny's post:
Highpower (02-03-2018), EdK (02-03-2018), arvidj (02-03-2018)

#15

02-03-2018, 07:55 PM

Well I'm happy to report that tape worked. TSC didn't have carpet tape so I used Gorilla mounting tape. It's some double sided rubbery stuff. I was even able to use the same pieces to do the back side of the same piece, then two new strips for the next one. Still have one more to go, the 8x10. I'm sticking them to a piece of corian, a sink cutout.

The problem with the mounting tape is that it's expensive. It's about $10 for 60". Depending on tonite/tomorrow's snow I'll be stopping at home depot for some carpet tape. More bang for the buck.

Thanks everyone!!! I'll post pics of the setup when I do the big one.

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Need some hold down advice - by Vinny - 02-02-2018, 01:27 PM

RE: Need some hold down advice - by dallen - 02-02-2018, 01:52 PM

RE: Need some hold down advice - by Vinny - 02-02-2018, 02:17 PM

RE: Need some hold down advice - by wawoodman - 02-02-2018, 02:55 PM

RE: Need some hold down advice - by Vinny - 02-02-2018, 03:02 PM

RE: Need some hold down advice - by Dr Stan - 02-02-2018, 03:43 PM

RE: Need some hold down advice - by TomG - 02-02-2018, 04:16 PM

RE: Need some hold down advice - by randyc - 02-02-2018, 04:38 PM