|
My First Project
|
02-03-2018, 11:14 AM
When I was building & rebuilding chain makers at Columbus McKinnon I ran a Lucas boring mill machining the main castings. They were cut dry and my roughing tool was a 12 or 18 inch carbide insert face mill. Half inch deep cuts using about 95% of the width. I would leave work some nights looking like a coal miner.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
My First Project - by Cross Slide - 12-10-2017, 07:03 PM
RE: My First Project - by EdK - 12-10-2017, 07:09 PM
RE: My First Project - by SteveG - 12-11-2017, 01:54 AM
RE: My First Project - by pepi - 12-11-2017, 07:09 AM
RE: My First Project - by Mayhem - 12-11-2017, 08:17 AM
RE: My First Project - by Highpower - 12-11-2017, 10:27 AM
RE: My First Project - by EdK - 12-11-2017, 08:34 AM
RE: My First Project - by TomG - 12-11-2017, 09:00 AM
RE: My First Project - by EdK - 12-11-2017, 05:53 PM
RE: My First Project - by Mayhem - 12-12-2017, 07:10 AM
RE: My First Project - by EdK - 12-12-2017, 05:11 PM
RE: My First Project - by Highpower - 12-12-2017, 11:38 AM
RE: My First Project - by f350ca - 12-12-2017, 01:48 PM
RE: My First Project - by EdK - 12-12-2017, 05:14 PM
RE: My First Project - by Dr Stan - 02-03-2018, 11:14 AM
|
