01-24-2018, 07:13 AM
Willie (Highpower) wrote.
I also recommend wiring the VFD and 3 phase motor together (on the bench or on the floor) and make sure you can get it running first before installing them on the lathe. Baby steps.
I tried the bench test and thought I was home free but when I did the installation on my mill the motor didn't have the "oomph" to turn the mill pulley.
I either didn't program the VFD right or the 3 phase motor isn't any good.
I guess I should take the 3 phase motor to an motor repair shop and have it tested and, if I'm lucky they might be able to program the
Huanyang HY04D023B properly.
I also recommend wiring the VFD and 3 phase motor together (on the bench or on the floor) and make sure you can get it running first before installing them on the lathe. Baby steps.
I tried the bench test and thought I was home free but when I did the installation on my mill the motor didn't have the "oomph" to turn the mill pulley.
I either didn't program the VFD right or the 3 phase motor isn't any good.
I guess I should take the 3 phase motor to an motor repair shop and have it tested and, if I'm lucky they might be able to program the
Huanyang HY04D023B properly.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.