Grizzly G0602 VFD conversion

[Highpower]

(01-22-2018, 09:18 PM)sun20ma Wrote: I am getting the wiring somewhat but the direction switch on the lathe has mumerous contacts and wiring and  the schematic  just shows DI1 and DI2    sorry for the ignorance  THX for time and help

I'm afraid I can't offer a simple solution other than to hire an electrician. With a multiple pole - multiple throw switch like that it takes a lot of time to map out the switch contacts with an ohmmeter since Grizzly doesn't supply a table for that.

p.s.
A tip for when you are replying to a post:
Start typing your reply after the last quote tag, not before it. Instead of this:

Quote:I am getting the wiring somewhat but the direction switch on the lathe has mumerous contacts and wiring and  the schematic  just shows DI1 and DI2    sorry for the ignorance  THX for time and help
{/quote}

Start typing below the last quote tag like this:

Quote:{/quote}
I am getting the wiring somewhat but the direction switch on the lathe has mumerous contacts and wiring and  the schematic  just shows DI1 and DI2    sorry for the ignorance  THX for time and help

It's no big deal. It will just make it easier to find your text if it's not mixed in with a previous quote.