Boring a tapered hole

Thread Modes

Boring a tapered hole

Dr Stan Offline

Senior

Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines

#24

01-20-2018, 10:55 AM

Overall a good plan, but I'd make one change. Instead of filling the hole with weld I'd drill or bore it so you could install a bushing and weld it in place. Finish the ID after welding. This would reduce the amount of embrittlement (sp?) and warping.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Boring a tapered hole - by Pete O - 12-23-2017, 05:06 AM

RE: Boring a tapered hole - by Mayhem - 12-23-2017, 05:43 AM

RE: Boring a tapered hole - by Pete O - 12-23-2017, 06:30 AM

RE: Boring a tapered hole - by Mayhem - 12-23-2017, 09:33 AM

RE: Boring a tapered hole - by TomG - 12-23-2017, 09:47 AM

RE: Boring a tapered hole - by Highpower - 12-23-2017, 10:58 AM

RE: Boring a tapered hole - by f350ca - 12-23-2017, 11:27 AM

RE: Boring a tapered hole - by Dr Stan - 12-23-2017, 02:54 PM

RE: Boring a tapered hole - by Pete O - 12-23-2017, 05:10 PM