MetalworkingFun Forum › Machining › General Metalworking Discussion v
Boring a tapered hole

Thread Modes
Boring a tapered hole
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#21
01-19-2018, 08:31 PM
(01-03-2018, 11:22 PM)Vinny Wrote: FBH, does that have something to do with a Big Hammer?  If so, I always called it a BFH.  Rolls off the tongue easier.

BMFH has been my go to tool.   Big Grin
Reply
Thanks given by:


Messages In This Thread
Boring a tapered hole - by Pete O - 12-23-2017, 05:06 AM
RE: Boring a tapered hole - by Mayhem - 12-23-2017, 05:43 AM
RE: Boring a tapered hole - by Pete O - 12-23-2017, 06:30 AM
RE: Boring a tapered hole - by Mayhem - 12-23-2017, 09:33 AM
RE: Boring a tapered hole - by TomG - 12-23-2017, 09:47 AM
RE: Boring a tapered hole - by Highpower - 12-23-2017, 10:58 AM
RE: Boring a tapered hole - by f350ca - 12-23-2017, 11:27 AM
RE: Boring a tapered hole - by Dr Stan - 12-23-2017, 02:54 PM
RE: Boring a tapered hole - by Pete O - 12-23-2017, 05:10 PM
RE: Boring a tapered hole - by randyc - 12-23-2017, 06:54 PM
RE: Boring a tapered hole - by Pete O - 01-03-2018, 06:45 PM
RE: Boring a tapered hole - by Dr Stan - 01-19-2018, 03:27 PM
RE: Boring a tapered hole - by f350ca - 01-03-2018, 09:00 PM
RE: Boring a tapered hole - by Pete O - 01-03-2018, 09:07 PM
RE: Boring a tapered hole - by SteveG - 01-03-2018, 09:20 PM
RE: Boring a tapered hole - by Pete O - 01-03-2018, 11:15 PM
RE: Boring a tapered hole - by Vinny - 01-03-2018, 11:22 PM
RE: Boring a tapered hole - by SteveG - 01-13-2018, 05:42 AM
RE: Boring a tapered hole - by Dr Stan - 01-19-2018, 08:31 PM
RE: Boring a tapered hole - by kwoodhands - 01-13-2018, 04:42 AM
RE: Boring a tapered hole - by pepi - 01-19-2018, 06:58 PM
RE: Boring a tapered hole - by Dr Stan - 01-19-2018, 08:36 PM
RE: Boring a tapered hole - by pepi - 01-20-2018, 08:05 AM
RE: Boring a tapered hole - by Dr Stan - 01-20-2018, 10:55 AM



Users browsing this thread: 1 Guest(s)