MetalworkingFun Forum › Machining › Projects v
Fabricated angle plate

Thread Modes
Fabricated angle plate
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#8
01-15-2018, 01:00 PM (This post was last modified: 01-15-2018, 01:03 PM by Dr Stan.)
When ever you cut a slot it needs to be cut with an undersized end mill as they will pull off to one side and cut oversized.  A keyway cutter performs better, but will still pull & cut oversized.  This is especially important when cutting key seats in shafts.

BTW, the angle plate looks good. Thumbsup
Reply
Thanks given by:


Messages In This Thread
Fabricated angle plate - by SteveG - 01-14-2018, 01:35 AM
RE: Fabricated angle plate - by SteveG - 01-14-2018, 01:38 AM
RE: Fabricated angle plate - by f350ca - 01-14-2018, 10:32 AM
RE: Fabricated angle plate - by Mayhem - 01-14-2018, 11:04 AM
RE: Fabricated angle plate - by pepi - 01-14-2018, 06:50 PM
RE: Fabricated angle plate - by SteveG - 01-15-2018, 02:39 AM
RE: Fabricated angle plate - by f350ca - 01-15-2018, 10:00 AM
RE: Fabricated angle plate - by Dr Stan - 01-15-2018, 01:00 PM
RE: Fabricated angle plate - by SteveG - 01-15-2018, 04:59 PM
RE: Fabricated angle plate - by Dr Stan - 01-16-2018, 11:50 AM



Users browsing this thread: 1 Guest(s)