01-03-2018, 09:20 PM
That's an awesome bit of gear.
If you're still looking to make the taper, one suggestion I found online that hasn't been posted here is to fill the hole in slightly with weld, clean up a bit then heat it up red hot or better and use a male taper (ie old ball joint with a good condition taper) and FBH to forge the hole back to tapered.
Steve
If you're still looking to make the taper, one suggestion I found online that hasn't been posted here is to fill the hole in slightly with weld, clean up a bit then heat it up red hot or better and use a male taper (ie old ball joint with a good condition taper) and FBH to forge the hole back to tapered.
Steve