06-24-2012, 03:29 PM
I want to make a 1" x 8TPI tap to use on blind holes in hardwood forms to try my hand at metal spinning. My question is since the tap is for wood only, do the flutes need to be deeper or different then one for metal?
|
Making a Tap Question???
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Making a Tap Question??? - by November X-ray - 06-24-2012, 03:29 PM
RE: Making a Tap Question??? - by doubleboost - 06-24-2012, 04:10 PM
RE: Making a Tap Question??? - by TomG - 06-24-2012, 04:19 PM
RE: Making a Tap Question??? - by November X-ray - 06-24-2012, 04:32 PM
RE: Making a Tap Question??? - by TomG - 06-24-2012, 05:07 PM
RE: Making a Tap Question??? - by f350ca - 06-24-2012, 05:13 PM
|
Users browsing this thread: 2 Guest(s)