MetalworkingFun Forum › Machining › General Metalworking Discussion v
Boring a tapered hole

Thread Modes
Boring a tapered hole
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
Highpower (12-23-2017)
#4
12-23-2017, 09:33 AM
I wouldn't cut it off. Simply drill it out and turn up a sleeve with the right tapered bore. No need to buy any tools - well none for that job but I'm sure you could use it as an excuse to buy some anyway...
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Boring a tapered hole - by Pete O - 12-23-2017, 05:06 AM
RE: Boring a tapered hole - by Mayhem - 12-23-2017, 05:43 AM
RE: Boring a tapered hole - by Pete O - 12-23-2017, 06:30 AM
RE: Boring a tapered hole - by Mayhem - 12-23-2017, 09:33 AM
RE: Boring a tapered hole - by TomG - 12-23-2017, 09:47 AM
RE: Boring a tapered hole - by Highpower - 12-23-2017, 10:58 AM
RE: Boring a tapered hole - by f350ca - 12-23-2017, 11:27 AM
RE: Boring a tapered hole - by Dr Stan - 12-23-2017, 02:54 PM
RE: Boring a tapered hole - by Pete O - 12-23-2017, 05:10 PM
RE: Boring a tapered hole - by randyc - 12-23-2017, 06:54 PM
RE: Boring a tapered hole - by Pete O - 01-03-2018, 06:45 PM
RE: Boring a tapered hole - by Dr Stan - 01-19-2018, 03:27 PM
RE: Boring a tapered hole - by f350ca - 01-03-2018, 09:00 PM
RE: Boring a tapered hole - by Pete O - 01-03-2018, 09:07 PM
RE: Boring a tapered hole - by SteveG - 01-03-2018, 09:20 PM
RE: Boring a tapered hole - by Pete O - 01-03-2018, 11:15 PM
RE: Boring a tapered hole - by Vinny - 01-03-2018, 11:22 PM
RE: Boring a tapered hole - by SteveG - 01-13-2018, 05:42 AM
RE: Boring a tapered hole - by Dr Stan - 01-19-2018, 08:31 PM
RE: Boring a tapered hole - by kwoodhands - 01-13-2018, 04:42 AM
RE: Boring a tapered hole - by pepi - 01-19-2018, 06:58 PM
RE: Boring a tapered hole - by Dr Stan - 01-19-2018, 08:36 PM
RE: Boring a tapered hole - by pepi - 01-20-2018, 08:05 AM
RE: Boring a tapered hole - by Dr Stan - 01-20-2018, 10:55 AM



Users browsing this thread: 2 Guest(s)