MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Switching To A QCTP

Thread Modes
Help Switching To A QCTP
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#5
12-12-2017, 06:28 AM
I had to press out the existing stud and make a new one, as the original was way too big. I made a sleeve up so I could use the old 4-way holder but it has never been used!
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Switching To A QCTP - by Cross Slide - 12-10-2017, 10:14 PM
RE: Switching To A QCTP - by Pete O - 12-11-2017, 05:07 AM
RE: Switching To A QCTP - by Dr Stan - 12-11-2017, 07:52 PM
RE: Switching To A QCTP - by Cross Slide - 12-11-2017, 11:05 PM
RE: Switching To A QCTP - by Mayhem - 12-12-2017, 06:28 AM
RE: Switching To A QCTP - by randyc - 12-12-2017, 07:35 PM
RE: Switching To A QCTP - by f350ca - 12-12-2017, 09:16 PM
RE: Switching To A QCTP - by randyc - 12-12-2017, 10:31 PM
RE: Switching To A QCTP - by randyc - 12-12-2017, 10:50 PM
RE: Switching To A QCTP - by f350ca - 12-13-2017, 12:08 AM
RE: Switching To A QCTP - by randyc - 12-13-2017, 03:00 PM
RE: Switching To A QCTP - by randyc - 12-13-2017, 04:15 PM



Users browsing this thread: 1 Guest(s)