MetalworkingFun Forum › Machining › Projects v
My First Project

Thread Modes
My First Project
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#2
12-10-2017, 07:09 PM
(12-10-2017, 07:03 PM)Cross Slide Wrote: Am I correct at thinking it would be 1018?

Yes, that's probably what it's made from. You can get key stock in other steels but it's typically made from 1018. At least that's what McMaster says their key stock is made from.

Ed
Reply
Thanks given by:


Messages In This Thread
My First Project - by Cross Slide - 12-10-2017, 07:03 PM
RE: My First Project - by EdK - 12-10-2017, 07:09 PM
RE: My First Project - by SteveG - 12-11-2017, 01:54 AM
RE: My First Project - by pepi - 12-11-2017, 07:09 AM
RE: My First Project - by Mayhem - 12-11-2017, 08:17 AM
RE: My First Project - by Highpower - 12-11-2017, 10:27 AM
RE: My First Project - by EdK - 12-11-2017, 08:34 AM
RE: My First Project - by TomG - 12-11-2017, 09:00 AM
RE: My First Project - by EdK - 12-11-2017, 05:53 PM
RE: My First Project - by Mayhem - 12-12-2017, 07:10 AM
RE: My First Project - by EdK - 12-12-2017, 05:11 PM
RE: My First Project - by Highpower - 12-12-2017, 11:38 AM
RE: My First Project - by f350ca - 12-12-2017, 01:48 PM
RE: My First Project - by EdK - 12-12-2017, 05:14 PM
RE: My First Project - by Dr Stan - 02-03-2018, 11:14 AM



Users browsing this thread: 1 Guest(s)