MetalworkingFun Forum › Machining › Projects v
Ball Turner Start

Thread Modes
Ball Turner Start
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#8
06-24-2012, 01:16 PM
Paul, (if that is your real name) I think that is WAY too much information. I think we should all disavow any knowledge or connection with you Cool.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Ball Turner Start - by pjf134 - 06-23-2012, 11:10 PM
RE: Ball Turner Start - by DaveH - 06-24-2012, 07:04 AM
RE: Ball Turner Start - by stevec - 06-24-2012, 07:11 AM
RE: Ball Turner Start - by TomG - 06-24-2012, 08:43 AM
RE: Ball Turner Start - by pjf134 - 06-24-2012, 08:46 AM
RE: Ball Turner Start - by pjf134 - 06-24-2012, 08:53 AM
RE: Ball Turner Start - by ETC57 - 06-24-2012, 09:29 AM
RE: Ball Turner Start - by stevec - 06-24-2012, 01:16 PM
RE: Ball Turner Start - by doubleboost - 06-24-2012, 02:46 PM
RE: Ball Turner Start - by pjf134 - 06-24-2012, 08:54 PM



Users browsing this thread: 1 Guest(s)