11-29-2017, 08:59 AM
With partial profile you machine the stock to the nominal size that you would if you were cutting the thread with a ground HSS bit. For example, for M10 external thread, I would machine the stock to 9.85mm.
With a full profile M10 insert you simply turn the stock to 10mm. The insert then removes the OD once you reach the correct depth, as it forms the crest on the top of the thread. As a result, you get the correct radius for that particular thread profile.
With a full profile M10 insert you simply turn the stock to 10mm. The insert then removes the OD once you reach the correct depth, as it forms the crest on the top of the thread. As a result, you get the correct radius for that particular thread profile.
Hunting American dentists since 2015.