MetalworkingFun Forum › Machining › General Metalworking Discussion v
Joining cast iron and steel

Thread Modes
Joining cast iron and steel
randyc Offline
Sophmore
***
Posts: 215
Threads: 22
Joined: Jul 2017
Location: Eureka, CA, USA
#12
11-19-2017, 05:21 PM
(11-19-2017, 12:41 AM)Dr Stan Wrote: ......If you have a needle scalier it should do a good job of peening W/O sending a bunch of vibrations through your hands & wrists.

That's what I used - piece o' cake.
Reply
Thanks given by:


Messages In This Thread
Joining cast iron and steel - by SteveG - 11-17-2017, 08:08 PM
RE: Joining cast iron and steel - by Dr Stan - 11-17-2017, 11:46 PM
RE: Joining cast iron and steel - by Robert - 11-18-2017, 08:26 AM
RE: Joining cast iron and steel - by Highpower - 11-18-2017, 12:33 PM
RE: Joining cast iron and steel - by Dr Stan - 11-18-2017, 02:04 PM
RE: Joining cast iron and steel - by randyc - 11-18-2017, 05:12 PM
RE: Joining cast iron and steel - by SteveG - 11-18-2017, 11:04 PM
RE: Joining cast iron and steel - by Dr Stan - 11-19-2017, 12:41 AM
RE: Joining cast iron and steel - by Highpower - 11-19-2017, 10:53 AM
RE: Joining cast iron and steel - by randyc - 11-19-2017, 05:21 PM
RE: Joining cast iron and steel - by SteveG - 11-19-2017, 05:41 AM
RE: Joining cast iron and steel - by Dr Stan - 11-19-2017, 09:59 AM



Users browsing this thread: 1 Guest(s)