11-19-2017, 10:53 AM
(11-19-2017, 12:41 AM)Dr Stan Wrote: If you have a needle scalier it should do a good job of peening
Whatever the method used, peening the weld beads afterwards to help relieve stresses is a good point.
Willie
|
Joining cast iron and steel
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Joining cast iron and steel - by SteveG - 11-17-2017, 08:08 PM
RE: Joining cast iron and steel - by Dr Stan - 11-17-2017, 11:46 PM
RE: Joining cast iron and steel - by Robert - 11-18-2017, 08:26 AM
RE: Joining cast iron and steel - by Highpower - 11-18-2017, 12:33 PM
RE: Joining cast iron and steel - by Dr Stan - 11-18-2017, 02:04 PM
RE: Joining cast iron and steel - by randyc - 11-18-2017, 05:12 PM
RE: Joining cast iron and steel - by SteveG - 11-18-2017, 11:04 PM
RE: Joining cast iron and steel - by Dr Stan - 11-19-2017, 12:41 AM
RE: Joining cast iron and steel - by Highpower - 11-19-2017, 10:53 AM
RE: Joining cast iron and steel - by randyc - 11-19-2017, 05:21 PM
RE: Joining cast iron and steel - by SteveG - 11-19-2017, 05:41 AM
RE: Joining cast iron and steel - by Dr Stan - 11-19-2017, 09:59 AM
|
Users browsing this thread: 1 Guest(s)