11-19-2017, 07:26 AM
I usually make it 0.010" undersize and then take that off in a final pass.
Hunting American dentists since 2015.
|
General question; milling slots
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
General question; milling slots - by pepi - 11-19-2017, 07:23 AM
RE: General question; milling slots - by Mayhem - 11-19-2017, 07:26 AM
RE: General question; milling slots - by awemawson - 11-19-2017, 09:10 AM
RE: General question; milling slots - by TomG - 11-19-2017, 09:45 AM
RE: General question; milling slots - by pepi - 11-19-2017, 11:19 AM
RE: General question; milling slots - by TomG - 11-19-2017, 02:50 PM
RE: General question; milling slots - by pepi - 11-20-2017, 07:24 AM
RE: General question; milling slots - by Dr Stan - 11-19-2017, 10:07 AM
RE: General question; milling slots - by f350ca - 11-19-2017, 01:41 PM
RE: General question; milling slots - by randyc - 11-20-2017, 06:43 PM
RE: General question; milling slots - by Dr Stan - 11-21-2017, 09:40 AM
RE: General question; milling slots - by pepi - 11-22-2017, 07:36 AM
|
Users browsing this thread: 3 Guest(s)