11-08-2017, 02:58 PM
Hi Guys
NO tricks. Only treats.
And if U a Full Nut, then U have to be "On Guard", Not Engaged. U must be married. Otherwise, stay enraged. Oh well. Dis Englez by another tongue.
Yes. U Guys are all correct. However, no matter how hard I tried, just could not Engage on any of the LCT1-8W Settings. Tried even fiddling with the Lead Screw, No Dice. Seemed like there was nothing in "W" Engagement. Another kind Gent on the other Forum sent me a Grizzly Catalogue of the exact same machine, albeit with very few minor differences. What a nice comprehensive detailed well explained printing. World of a difference compared to mine. He suggested changing some Gear,(really don't know much about those complications) Problem is U GUys have imperial Leadscrews whilst we have Metric. Don't know if I will bugger up the Thread Cutting pitches by installing One of the Gears supplied with the Machine. Need to count them Teeth and see which Numbers he specified. And see if that will get the "W" Setting to Engage, before we get Enraged !!!
Must say U still got a good eye, Tom. :-)
Regret hanging my snakes here.
Do really appreciate the informality and the kind responses. Thanks a zillion again.
Warm regards
ATB
aRM
NO tricks. Only treats.
And if U a Full Nut, then U have to be "On Guard", Not Engaged. U must be married. Otherwise, stay enraged. Oh well. Dis Englez by another tongue.
Yes. U Guys are all correct. However, no matter how hard I tried, just could not Engage on any of the LCT1-8W Settings. Tried even fiddling with the Lead Screw, No Dice. Seemed like there was nothing in "W" Engagement. Another kind Gent on the other Forum sent me a Grizzly Catalogue of the exact same machine, albeit with very few minor differences. What a nice comprehensive detailed well explained printing. World of a difference compared to mine. He suggested changing some Gear,(really don't know much about those complications) Problem is U GUys have imperial Leadscrews whilst we have Metric. Don't know if I will bugger up the Thread Cutting pitches by installing One of the Gears supplied with the Machine. Need to count them Teeth and see which Numbers he specified. And see if that will get the "W" Setting to Engage, before we get Enraged !!!
Must say U still got a good eye, Tom. :-)
Regret hanging my snakes here.
Do really appreciate the informality and the kind responses. Thanks a zillion again.
Warm regards
ATB
aRM