06-24-2012, 04:11 AM
Hello All,
I can vouch for these old TOS Mills, I used one as an Apprentice, and it was every bit as good as anything "Western" if not quite as fancy as a Cinncinati, They are a good solid machine that gets the job done.
Hello Welrod,
Does the vertical head have the 2:1 stepup? If I remember correctly there were two vertical head ratios on the one I used, might have been 2:1 and 4:1 or 1:1 and 2:1.
Well done, going for a proper old school Mill, it's not the easy choice for a hobbyist.
Best Regards
Rick
I can vouch for these old TOS Mills, I used one as an Apprentice, and it was every bit as good as anything "Western" if not quite as fancy as a Cinncinati, They are a good solid machine that gets the job done.
Hello Welrod,
Does the vertical head have the 2:1 stepup? If I remember correctly there were two vertical head ratios on the one I used, might have been 2:1 and 4:1 or 1:1 and 2:1.
Well done, going for a proper old school Mill, it's not the easy choice for a hobbyist.
Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.