Latest Delivery

[pepi]

(10-27-2017, 09:01 AM)awemawson Wrote: 'Dead blow' hammer stops the bounce back - (hollow hammer filled with lead shot)

 Thank you, using a brass hammer, got a dead blow I can try...

(10-27-2017, 08:38 AM)Highpower Wrote: I run into that from time to time if I get in too much of a hurry and tamp down on the part a little too hard. It bounces back off of the parallel(s) just enough to let them slide under the part. Light taps work better for me. Possibly a difference in the materials between your blank and your 1-2-3 block causing a difference in rebound?

Did you deburr the edges of your blank after milling? I've been caught up by a sharp edge of a part hitting an inside corner of the vice in the past as well. Again my fault, for being in a hurry and deburring 11 edges of a block instead of all 12.  

Thank you good points, regarding the bounce I do pound, will try backing off, yes deburr all 12 edges LMAO


Greg