10-19-2017, 08:40 PM
Moving the rest of this post started in new arrivals. Another trip to the bandsaw produced a blank with dimensions. Some lathe work, drilling and boring a hole too 1 5/16 for the bearings.
Back to the mill, drilled two 7/16 relief holes in the corners.
Again back to the bandsaw for a trim to ruff finish dimensions.
Cleaned up for a photo, what's left some finish milling. Drill a hole to be tapped for a set screw that fits a grove in the bearing, preventing the bearing from walking. On the tabs slots for the belt and chain tension.
Greg
Back to the mill, drilled two 7/16 relief holes in the corners.
Again back to the bandsaw for a trim to ruff finish dimensions.
Cleaned up for a photo, what's left some finish milling. Drill a hole to be tapped for a set screw that fits a grove in the bearing, preventing the bearing from walking. On the tabs slots for the belt and chain tension.
Greg
Magazines have issues, everything else has problems