My new to me Rockwell Radial Arm Drill Press. Supposedly it came out of a Ford transmission factory, I guess the maintenance shop. There's a small crack in one corner of the table near a leg. I'll get some nickel rod and repair it.
The vice on the other hand will require major surgery. I have some cast iron from my conversion of my press so Ill probably make an insert for the vice once I've milled out the damage. Probably bolt & pin it in place rather than weld it. Have to see once I've started chewing on it. The jaws will need to be replaced or re machined.
BTW, notice the shift pattern on the knobs.