Milling sub plate.Gett

Hello There, Guest! Register

Thread Modes

Milling sub plate.Gett

contraptioneer Offline

Offline

Freshman

Posts: 30
Threads: 3
Joined: Sep 2017
Location: Michigan U.S.A.

The following 2 users Like contraptioneer's post:
f350ca (10-09-2017), Pete O (10-12-2017)

#20

10-07-2017, 09:40 PM

This shows the completed drilling and tapping.

.jpg

.jpg

image003.jpg (Size: 64.85 KB / Downloads: 47)

And this one shows the inserts installed.

.jpg

.jpg

image008.jpg (Size: 61 KB / Downloads: 46)

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Milling sub plate.Gett - by contraptioneer - 09-25-2017, 09:18 PM

RE: Milling sub plate.Gett - by Dr Stan - 09-25-2017, 09:27 PM

RE: Milling sub plate.Gett - by Highpower - 09-26-2017, 04:20 AM

RE: Milling sub plate.Gett - by TomG - 09-26-2017, 09:01 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-26-2017, 08:59 PM

RE: Milling sub plate.Gett - by f350ca - 09-26-2017, 09:22 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-27-2017, 12:00 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:29 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:33 PM

RE: Milling sub plate.Gett - by Vinny - 09-28-2017, 09:35 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 10:32 PM

RE: Milling sub plate.Gett - by Vinny - 09-29-2017, 05:59 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:08 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:17 PM

RE: Milling sub plate.Gett - by the penguin - 09-30-2017, 10:02 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-30-2017, 11:50 AM

RE: Milling sub plate.Gett - by contraptioneer - 10-04-2017, 10:15 PM

RE: Milling sub plate.Gett - by Highpower - 10-04-2017, 11:11 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:32 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:40 PM

Users browsing this thread: 1 Guest(s)