Question about my mill.

Thread Modes

Question about my mill.

contraptioneer Offline

Freshman

Posts: 30
Threads: 3
Joined: Sep 2017
Location: Michigan U.S.A.

#12

10-02-2017, 04:25 PM

Thanks Tom. Yep I adjusted Z axis also. While cranking up or down the table had a very slight wobble on the X axis. it does not now and I attribute that to the adjustment of of the Z axis gib. All in all she is in a bit better shape than she has been.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Question about my mill. - by contraptioneer - 09-28-2017, 08:43 PM

RE: Question about my mill. - by Roadracer_Al - 09-29-2017, 04:19 AM

RE: Question about my mill. - by TomG - 09-29-2017, 08:16 AM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:39 PM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:41 PM

RE: Question about my mill. - by TomG - 09-29-2017, 10:14 PM

RE: Question about my mill. - by contraptioneer - 09-30-2017, 12:32 PM

RE: Question about my mill. - by Hawkeye - 09-30-2017, 10:31 PM

RE: Question about my mill. - by contraptioneer - 10-01-2017, 12:25 PM