MetalworkingFun Forum › Machinery › Milling Machines v
Question about my mill.

Thread Modes
Question about my mill.
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
hermetic (10-02-2017)
#11
10-01-2017, 09:18 PM
Sounds like you've made some good progress. Make sure the gibs on the Z axis are tight as well, as that can contribute to movement as the table travels from one extreme to the other.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Question about my mill. - by contraptioneer - 09-28-2017, 08:43 PM
RE: Question about my mill. - by Roadracer_Al - 09-29-2017, 04:19 AM
RE: Question about my mill. - by TomG - 09-29-2017, 08:16 AM
RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:39 PM
RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:41 PM
RE: Question about my mill. - by TomG - 09-29-2017, 10:14 PM
RE: Question about my mill. - by contraptioneer - 09-30-2017, 12:32 PM
RE: Question about my mill. - by Hawkeye - 09-30-2017, 10:31 PM
RE: Question about my mill. - by contraptioneer - 10-01-2017, 12:25 PM
RE: Question about my mill. - by contraptioneer - 10-01-2017, 08:11 PM
RE: Question about my mill. - by TomG - 10-01-2017, 09:18 PM
RE: Question about my mill. - by contraptioneer - 10-02-2017, 04:25 PM
RE: Question about my mill. - by Dr Stan - 10-02-2017, 07:07 PM
RE: Question about my mill. - by contraptioneer - 10-02-2017, 07:33 PM
RE: Question about my mill. - by randyc - 10-14-2017, 10:36 PM
RE: Question about my mill. - by contraptioneer - 10-15-2017, 07:55 PM



Users browsing this thread: 1 Guest(s)