Question about my mill.

Thread Modes

Question about my mill.

contraptioneer Offline

Freshman

Posts: 30
Threads: 3
Joined: Sep 2017
Location: Michigan U.S.A.

#10

10-01-2017, 08:11 PM

Well it took pretty much standing on my head and a considerable amount of mining through several layers of crud and paint but I did find the gib screws and was able to get some adjustment. Enough to get it down to just under .002 in 14 inches of travel.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Question about my mill. - by contraptioneer - 09-28-2017, 08:43 PM

RE: Question about my mill. - by Roadracer_Al - 09-29-2017, 04:19 AM

RE: Question about my mill. - by TomG - 09-29-2017, 08:16 AM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:39 PM

RE: Question about my mill. - by contraptioneer - 09-29-2017, 04:41 PM

RE: Question about my mill. - by TomG - 09-29-2017, 10:14 PM

RE: Question about my mill. - by contraptioneer - 09-30-2017, 12:32 PM

RE: Question about my mill. - by Hawkeye - 09-30-2017, 10:31 PM

RE: Question about my mill. - by contraptioneer - 10-01-2017, 12:25 PM