Milling sub plate.Gett

Hello There, Guest! Register

Thread Modes

Milling sub plate.Gett

the penguin Offline

Offline

Junior

Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny

The following 1 user Likes the penguin's post:
f350ca (09-30-2017)

#15

09-30-2017, 10:02 AM

The 12" x 24" fixture plate I made with the 256 threaded holes, is now attached to the Rockwell mill, at least for the time being.

Attached Files Thumbnail(s)

jack

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Milling sub plate.Gett - by contraptioneer - 09-25-2017, 09:18 PM

RE: Milling sub plate.Gett - by Dr Stan - 09-25-2017, 09:27 PM

RE: Milling sub plate.Gett - by Highpower - 09-26-2017, 04:20 AM

RE: Milling sub plate.Gett - by TomG - 09-26-2017, 09:01 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-26-2017, 08:59 PM

RE: Milling sub plate.Gett - by f350ca - 09-26-2017, 09:22 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-27-2017, 12:00 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:29 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:33 PM

RE: Milling sub plate.Gett - by Vinny - 09-28-2017, 09:35 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 10:32 PM

RE: Milling sub plate.Gett - by Vinny - 09-29-2017, 05:59 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:08 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:17 PM

RE: Milling sub plate.Gett - by the penguin - 09-30-2017, 10:02 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-30-2017, 11:50 AM

RE: Milling sub plate.Gett - by contraptioneer - 10-04-2017, 10:15 PM

RE: Milling sub plate.Gett - by Highpower - 10-04-2017, 11:11 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:32 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:40 PM

Users browsing this thread: 1 Guest(s)