09-29-2017, 04:19 AM
You would tram the vise to get it parallel to the X axis.
You would not be able to tram the head at all.
If you measure the mill and find the head to be out of square to the table, you'd have to first figure out where the inacuracy is located - the table or the ways - then fix it at the source.... not at the head.
You would not be able to tram the head at all.
If you measure the mill and find the head to be out of square to the table, you'd have to first figure out where the inacuracy is located - the table or the ways - then fix it at the source.... not at the head.