Milling sub plate.Gett

Hello There, Guest! Register

Thread Modes

Milling sub plate.Gett

contraptioneer Offline

Offline

Freshman

Posts: 30
Threads: 3
Joined: Sep 2017
Location: Michigan U.S.A.

The following 1 user Likes contraptioneer's post:
EdK (09-28-2017)

#9

09-28-2017, 08:33 PM

Guess I should also say that I am starting my tap using the spindle for about 4 revs and finishing by hand so I can feel the stress on the tap.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Milling sub plate.Gett - by contraptioneer - 09-25-2017, 09:18 PM

RE: Milling sub plate.Gett - by Dr Stan - 09-25-2017, 09:27 PM

RE: Milling sub plate.Gett - by Highpower - 09-26-2017, 04:20 AM

RE: Milling sub plate.Gett - by TomG - 09-26-2017, 09:01 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-26-2017, 08:59 PM

RE: Milling sub plate.Gett - by f350ca - 09-26-2017, 09:22 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-27-2017, 12:00 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:29 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:33 PM

RE: Milling sub plate.Gett - by Vinny - 09-28-2017, 09:35 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 10:32 PM

RE: Milling sub plate.Gett - by Vinny - 09-29-2017, 05:59 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:08 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:17 PM

RE: Milling sub plate.Gett - by the penguin - 09-30-2017, 10:02 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-30-2017, 11:50 AM

RE: Milling sub plate.Gett - by contraptioneer - 10-04-2017, 10:15 PM

RE: Milling sub plate.Gett - by Highpower - 10-04-2017, 11:11 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:32 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:40 PM

Users browsing this thread: 1 Guest(s)