Milling sub plate.Gett

[contraptioneer]

F350ca; I see in the pic in your post that your mill table has 3 T slots for fixturing where as my mill has but one, which is the main reason for the new tooling plate. The single T slot on mine is just way to limiting. I do like the idea of using the plate non anchored as well. With so little experience on the mill it is sometimes hard to know what might be useful in the future. At this point though I can see where there could be uses for several different tooling plates in different sizes and configurations.                                                                                                                                                I have been a lurker here for a while and there is so much knowledge and experience here that I have seen and I`m sure I can benefit greatly by being here.