Milling sub plate.Gett

Hello There, Guest! Register

Thread Modes

Milling sub plate.Gett

Dr Stan Offline

Offline

Senior

Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines

#2

09-25-2017, 09:27 PM

I recommend going with 1" thick aluminum in an effort to reduce warping from stress relieving during machining.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Milling sub plate.Gett - by contraptioneer - 09-25-2017, 09:18 PM

RE: Milling sub plate.Gett - by Dr Stan - 09-25-2017, 09:27 PM

RE: Milling sub plate.Gett - by Highpower - 09-26-2017, 04:20 AM

RE: Milling sub plate.Gett - by TomG - 09-26-2017, 09:01 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-26-2017, 08:59 PM

RE: Milling sub plate.Gett - by f350ca - 09-26-2017, 09:22 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-27-2017, 12:00 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:29 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 08:33 PM

RE: Milling sub plate.Gett - by Vinny - 09-28-2017, 09:35 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-28-2017, 10:32 PM

RE: Milling sub plate.Gett - by Vinny - 09-29-2017, 05:59 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:08 PM

RE: Milling sub plate.Gett - by contraptioneer - 09-29-2017, 01:17 PM

RE: Milling sub plate.Gett - by the penguin - 09-30-2017, 10:02 AM

RE: Milling sub plate.Gett - by contraptioneer - 09-30-2017, 11:50 AM

RE: Milling sub plate.Gett - by contraptioneer - 10-04-2017, 10:15 PM

RE: Milling sub plate.Gett - by Highpower - 10-04-2017, 11:11 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:32 PM

RE: Milling sub plate.Gett - by contraptioneer - 10-07-2017, 09:40 PM

Users browsing this thread: 1 Guest(s)