SteveG's Van Norman #12 mill

Thread Modes

SteveG's Van Norman #12 mill

Vinny

Another Whipping Boy

Posts: 2,620
Threads: 100
Joined: Dec 2014
Location: Michigan

The following 1 user Likes Vinny's post:
f350ca (09-15-2017)

09-15-2017, 07:01 PM

This video might be helpful. It was done by a member here, don't recall seeing anything from him lately tho. It's about setting up the compound for that angle.

https://www.youtube.com/watch?v=YCllVu4K738

Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique

Website

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

SteveG's Van Norman #12 mill - by SteveG - 09-06-2017, 08:57 AM

RE: SteveG's Van Norman #12 mill - by SteveG - 09-06-2017, 09:23 AM

RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 02:11 AM

RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 04:54 AM

RE: SteveG's Van Norman #12 mill - by Vinny - 09-15-2017, 07:01 PM

RE: SteveG's Van Norman #12 mill - by SteveG - 09-15-2017, 10:51 PM

RE: SteveG's Van Norman #12 mill - by Pete O - 09-16-2017, 04:56 AM

RE: SteveG's Van Norman #12 mill - by SteveG - 09-16-2017, 08:06 AM