09-12-2017, 09:39 PM
The first surface grinders were modified planners. A shaper with a tool post grinder should work just fine, just don't try to take shaper hogging cuts with it. 
MetalworkingFun Forum
›
Machinery
›
Other Machinery
›
Shapers
Grinding head on a shaper - poor mans surface grinder??
Grinding head on a shaper - poor mans surface grinder??
|
Grinding head on a shaper - poor mans surface grinder??
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Grinding head on a shaper - poor mans surface grinder?? - by SteveG - 09-12-2017, 06:22 AM
RE: Grinding head on a shaper - poor mans surface grinder?? - by Mike E. - 09-12-2017, 01:39 PM
RE: Grinding head on a shaper - poor mans surface grinder?? - by Dr Stan - 09-12-2017, 09:39 PM
RE: Grinding head on a shaper - poor mans surface grinder?? - by SteveG - 09-13-2017, 02:13 AM
RE: Grinding head on a shaper - poor mans surface grinder?? - by Dr Stan - 09-13-2017, 10:35 PM
RE: Grinding head on a shaper - poor mans surface grinder?? - by SteveG - 09-14-2017, 11:36 PM
|
Users browsing this thread: 2 Guest(s)