08-30-2017, 04:45 PM
(08-30-2017, 02:03 PM)Alphonse Wrote: I think my dies mostly have divots in them at 180 degrees apart.
Here are a couple of holders for the lathe tailstock sliding die holders that I have.
Is this what you were asking?
Thanks for the response Alphonse, yes you have the right track but my dies have divots that apear to be 90deg apart ( 45deg each side of the the split in the die) I did some more invistigating on paper with a protractor and I'm sure they are 45deg each side of the split in the die.
Looking at your die holder & die it may be a good idea for me to put in an extra hole 180deg from one of my divot screws while I'm at the build stage, then I'll be covered if I get a die like yours with the divots 180 deg apart
Thanks for the info
