MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Making a die stock holder

Thread Modes
Help Making a die stock holder
Alphonse Offline
Professional Loafer
**
Posts: 14
Threads: 2
Joined: Aug 2017
Location: LA (Lower Alabama)
The following 1 user Likes Alphonse's post:
Andy T (08-30-2017)
#3
08-30-2017, 02:03 PM (This post was last modified: 08-30-2017, 02:05 PM by Alphonse.)
I think my dies mostly have divots in them at 180 degrees apart.  

Here are a couple of holders for the lathe tailstock sliding die holders that I have. 

Is this what you were asking?

   
Reply
Thanks given by: Andy T


Messages In This Thread
Making a die stock holder - by Andy T - 08-30-2017, 10:32 AM
RE: Making a die stock holder - by Highpower - 08-30-2017, 01:56 PM
RE: Making a die stock holder - by Alphonse - 08-30-2017, 02:03 PM
RE: Making a die stock holder - by Andy T - 08-30-2017, 04:45 PM
RE: Making a die stock holder - by DaveH - 09-05-2017, 06:58 PM



Users browsing this thread: 1 Guest(s)