MetalworkingFun Forum › Machining › How-To's v
No Transfer Punches ?

Thread Modes
No Transfer Punches ?
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#4
08-26-2017, 02:37 PM
I have a good selection of odd sizes of transfer punches I've made over the years. Normally I just use a piece of drill rod and turn the point and ring with a V shaped tool. Those transfer screws are very helpful as well, both the threaded and non threaded versions.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
No Transfer Punches ? - by randyc - 08-25-2017, 05:37 PM
RE: No Transfer Punches ? - by f350ca - 08-25-2017, 07:13 PM
RE: No Transfer Punches ? - by randyc - 08-25-2017, 08:58 PM
RE: No Transfer Punches ? - by TomG - 08-26-2017, 02:37 PM
RE: No Transfer Punches ? - by wawoodman - 08-30-2017, 01:30 PM
RE: No Transfer Punches ? - by Highpower - 08-30-2017, 01:59 PM
RE: No Transfer Punches ? - by Alphonse - 08-30-2017, 02:46 PM
RE: No Transfer Punches ? - by kwoodhands - 02-09-2018, 06:10 PM
RE: No Transfer Punches ? - by Vinny - 08-30-2017, 08:22 PM
RE: No Transfer Punches ? - by randyc - 08-30-2017, 09:23 PM
RE: No Transfer Punches ? - by Vinny - 08-30-2017, 09:26 PM
RE: No Transfer Punches ? - by Mayhem - 08-31-2017, 07:46 AM
RE: No Transfer Punches ? - by randyc - 08-31-2017, 04:54 PM
RE: No Transfer Punches ? - by Brian - 04-24-2018, 01:03 AM



Users browsing this thread: 2 Guest(s)