06-22-2012, 08:18 PM
(06-22-2012, 08:12 PM)TomG Wrote: The lap in your set up will tend to follow the tapered bore rather than correct it's misalignment. It looks like this lapping operation is normally done on a vertical mill with the spindle being dead perpendicular to the table. I don't know if you've seen this site, but here's a guy demonstrating it:
Cannonball and the Beast
There is also a ton of other info on flywheel alignment on the site.
Tom
I have and the problem with it that he indicates the bore of the taper but then does not fixed the wheel to the table. It's allowed to wander and seek it's own true.