Question about side & face mill tooth geometry.

Thread Modes

Question about side & face mill tooth geometry.

wawoodman Offline

Junior

Posts: 340
Threads: 24
Joined: Aug 2014
Location: Seattle, WA

07-19-2017, 10:58 AM

Speaking only from woodworking experience, I would think they should be tapered.

Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)

« Next Oldest | Next Newest »

Messages In This Thread

RE: Question about side&face mill tooth geometry. - by wawoodman - 07-19-2017, 10:58 AM

Users browsing this thread: 2 Guest(s)