07-16-2017, 02:03 PM
(07-16-2017, 07:51 AM)TomG Wrote: I've never used one, but if it's made by Cincinatti, it's going to be made well. Just be sure to check for wear in the middle of the table travel.
Tom
I understand the Toolmaster uses something other than R8 collets. One could rebore the spindle but I'm not sure that's really necessary. One could also buy a ER collet holder to make life simpler. That's what I did on my Fray as it takes a MT #2 collet. You'll loose a little on the Z axis, but that's not a big sacrifice IMHO.