06-23-2017, 02:31 PM
(06-22-2017, 09:16 PM)ScrapMetal Wrote: Thanks for the link to the converter but I've got that covered as I ran 3phase out to my shop a couple of years ago. On quick inspection the wires don't look/feel too bad but they'll get a good going over before I plug anything in.
I may have to re-arrange my little shop though. The guy running the auction pickup area showed me what they are putting up for auction next week, a Pratt & Whitney lathe, Hendey lathe, Standard Modern lathe, radial drill press, horizontal mill and a couple of surface grinders all in supposedly good working condition. I need a bigger shop.
-Ron
Where are you? Close to Kearney?????????????????????????