06-18-2017, 04:26 PM
Three possibilities: Your tool is not HSS, your work is not mild steel, or the cutting speed is way too high.
This would only make for a rough finish, but I don't see any side clearance on the tool. Check out the reference section on my website for proper clearance angles.
Tom
This would only make for a rough finish, but I don't see any side clearance on the tool. Check out the reference section on my website for proper clearance angles.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)