Harrison Milling Machine

[hermetic]

You can always trust Andrew to come up with simple brilliant repair ideas! I think I might be tempted to split the bush in two, and then fit it. I was lucky with my Harrison, the only corrosion was in the table thrust bearing, but it had spent more time standing in the metalwork shop at my old school that it had actually being used! Keep up the good work, it is looking excellent, and when complete, it will be a joy to use. If you have the manual you will know that most (but not all) of the nipples on the machine are for an oil gun, not a grease gun. When I finally bought one and went round the machine pressure oiling it, the difference was nothing short of astounding!!
Phil