Harrison Milling Machine

[Zoot Suit]

(06-11-2017, 02:27 PM)awemawson Wrote: A/ Machine shaft down below the level of the corrosion

B/ Turn up a bush that would be a sliding fit if you could get it on (but you can't !)

C/ Slit the bush

D/ Silver solder the bush onto the shaft tying the two halves together with wire as you do

E/ Machine bush / shaft assembly back to original size


Simples :)

Doh!  Of course it is. 

Thanks for the prompt awemawson, I feel a bit dim because I have done that once before. 

My excuse is that I was preoccupied in pondering my piston question in the "General" section.

John