06-11-2017, 02:27 PM
A/ Machine shaft down below the level of the corrosion
B/ Turn up a bush that would be a sliding fit if you could get it on (but you can't !)
C/ Slit the bush
D/ Silver solder the bush onto the shaft tying the two halves together with wire as you do
E/ Machine bush / shaft assembly back to original size
Simples :)
B/ Turn up a bush that would be a sliding fit if you could get it on (but you can't !)
C/ Slit the bush
D/ Silver solder the bush onto the shaft tying the two halves together with wire as you do
E/ Machine bush / shaft assembly back to original size
Simples :)
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.