|
Fitting a 5C Collet Chuck
|
06-09-2017, 10:59 PM
Your lathe comes with 125mm diameter chucks. That's about 5" so you should be able to use something like this:
http://www.shars.com/products/toolholdin...llet-chuck You'll have to make a back plate in order to mount it to your lathe. Ed |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fitting a 5C Collet Chuck - by Cross Slide - 06-09-2017, 10:18 PM
RE: Fitting a 5C Collet Chuck - by EdK - 06-09-2017, 10:59 PM
RE: Fitting a 5C Collet Chuck - by Cross Slide - 06-10-2017, 03:22 PM
RE: Fitting a 5C Collet Chuck - by ieezitin - 06-10-2017, 09:19 AM
RE: Fitting a 5C Collet Chuck - by Cross Slide - 06-10-2017, 03:07 PM
RE: Fitting a 5C Collet Chuck - by Mayhem - 06-10-2017, 09:40 AM
RE: Fitting a 5C Collet Chuck - by Cross Slide - 06-10-2017, 03:16 PM
RE: Fitting a 5C Collet Chuck - by the penguin - 06-12-2017, 06:46 AM
RE: Fitting a 5C Collet Chuck - by EdK - 06-12-2017, 05:33 PM
RE: Fitting a 5C Collet Chuck - by the penguin - 06-13-2017, 07:58 AM
RE: Fitting a 5C Collet Chuck - by Dr Stan - 06-13-2017, 12:37 PM
|
