MetalworkingFun Forum › Machining › General Metalworking Discussion v
New Drawbar For The Rockwell Mill

Thread Modes
New Drawbar For The Rockwell Mill
the penguin Offline
Junior
****
Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny
The following 5 users Like the penguin's post:
EdK (05-28-2017), f350ca (05-28-2017), Mayhem (05-29-2017), Roadracer_Al (05-29-2017), JScott (06-08-2017)
#2
05-28-2017, 10:53 AM
ended up being a simple project, an 11" piece of the 7/16"-20 B-7 hardened all-thread, a 7/16"-20 coupling nut, a couple of 1/8" roll pins and a quick plug weld and it was done.


Attached Files Thumbnail(s)
   
jack
Reply
Thanks given by:


Messages In This Thread
RE: New Drawbar For The Rockwell Mill - by the penguin - 05-28-2017, 10:53 AM



Users browsing this thread: 1 Guest(s)